the base adress of the camera control register

[Unregistered]

Hi,
I have read the manual for my XDC-X700 (file GDCDSX900E.pdf). And there I discovered the description of the base adress of the camera control register acquiring. There is written the base addres of the Configuration ROM is FFFF F0000000H.
My question is how I can read the data from this adress and how I can write to this adress with C++?
Thank you very much.


This message was originally posted by Julia in the old IC Imaging Control Support Forum.

[Unregistered]

Hello,

There is no way to access the camera registers directly from DirectShow because the WDM stream class driver encapsulates these details and hides them. From DirectShow, an therefore from IC Imaging Control, only the standard camera properties and special properties that are described by the DCAM Add-On, are available.

Best regards
Johannes
IC Support


This message was originally posted by Vogel in the old IC Imaging Control Support Forum.