Unregistered
October 28, 2002, 11:36:00
Hi,
I can put the state of capture on start and stop, but can i pause the capture session and then continue?
I use IC to capture from Medical device and sometime the doctor need to take only a portion of all operation. I use a pedal to start and stop the acquisition, but i take simple different video.I need to take one video without the use of a video tool.
If this is too hard also an append function to the last video is OK (with some video codec)
Thanks:)
Williams Piazza - IMAGO SNC
This message was originally posted by Willyx in the old IC Imaging Control Support Forum.
I can put the state of capture on start and stop, but can i pause the capture session and then continue?
I use IC to capture from Medical device and sometime the doctor need to take only a portion of all operation. I use a pedal to start and stop the acquisition, but i take simple different video.I need to take one video without the use of a video tool.
If this is too hard also an append function to the last video is OK (with some video codec)
Thanks:)
Williams Piazza - IMAGO SNC
This message was originally posted by Willyx in the old IC Imaging Control Support Forum.