Running more than one control

[Unregistered]

Hi,

I'm trying to use the software with a provideo card that supports 4/8 cams. If has 4 conexant chips on it and installs as 4 drivers ie capture 0, capture 1.....

Using the MS WDM utility I can run 4 versions and siplay all 4 cameras with no trouble. However, when I try to connect to more than one driver with your software the computer reboots itself. No error/blue screen just an instant reboot.

This happens anytime more than one control is run and trying to connect to another of the cards drivers. Any help/ideas appreciated.


This message was originally posted by Liz in the old IC Imaging Control Support Forum.

[Unregistered]

Hello,

Please send me a copy of the driver you are using. Imaging Control uses more complex functionality of a driver than most tools that come with the DirectShow SDK.

In addition we need to know more about your system setup. Please fill out the support form at:

http://www.imagingcontrol.com/ic/support/email/



Best reagards
Johannes
IC Support


This message was originally posted by Johannes in the old IC Imaging Control Support Forum.