PDA

View Full Version : Which Hirose pins to solder to BNC cable for triggering?



dhkuk
August 3, 2015, 20:15:48
Hi.

I need to solder the Hirose connector of the DMK 42BUC03 with an RG59 BNC cable for triggering.

I have tried soldering pin 1 (external ground) of the Hirose connector to the BNC ground, and pin 4 (octocoupler signal) with the BNC middle pin, but no triggering occurred.

Which Hirose pins should be connected to the BNC cable?

Thank you.

Stefan Geissler
August 4, 2015, 11:21:53
Why did you not conect the pins for trigger + and trigger -? They are pin 3 and 4 as shown on page 7 in the document at:
http://dl.theimagingsource.com/4d42b7006e/

http://www.theimagingsource.com/en_US/publications/whitepapers/