PDA

View Full Version : VisionPro acquisition ROI with DMK 23GM021



Maximus
February 28, 2014, 16:41:59
Dear support,
I am using VisionPro8.2 with a DMK 23GM021 camera.
I would like to set a reduced ROI on the sensor in order to increase the framerate.
I can set the Region on the Image Properties tab, but the camera still acquires the whole sensor.
It seem that this parameter is not sent to the camera by VisionPro.
The ROI works correctly using the ICImagingControl component of the SDK.

Is there any additional configuration to do within VisionPro?
I would like to keep using QuickBuild.

Thank you in advance for any help.
Best regards,
Max

1673

Stefan Geissler
February 28, 2014, 17:11:51
Hello

I suppose, you use the GigeVision implementation in Vision Pro, right? Then you should be able to set the ROI with the standard GigE Vision sets. Did you ask the Cognex Support about how to use their program? If not, I would have to install Vision Pro and look on my own.

Maybe you should not use the "image properties" but the "camera properties". Threre should be "width" and "height" as well as "fps" somewhere.