View Full Version : Strobe Problem

January 3, 2014, 02:11:20
I have a DMK 23G445 camera. I have written an application for my projector to trigger the camera. But i found that i can't see what's in the camera's view until i trigger the camera to snap a picture.

So I tried to trigger my projector through my camera. I want to know how to trigger the projector when I snap a picture.

P.S. I found that the output signal of the three strobe model make my projector keep flashing...

Stefan Geissler
January 6, 2014, 14:33:51

If the camera runs triggered, then it will provide an image only, if a trigger pulse occurs. Therefore you do not see anything, if your projector does not run and provides triggers. Therefore, for adjusting the camera and lens, you may start the projector and adjust them. Then you rewind the film and start the capture and projector.

I would not use the strobe to control the projector.