PDA

View Full Version : How to remove DFG/USB2pro from case



sky_123
January 11, 2013, 08:16:21
Hello,

I have a DFG/USB2pro and I'd like to mount the bare board inside a chassis, but I couldn't figure out how to
open the plastic case without damaging the case!

Any tips on how it is assembled - is it glued?

I'd like to remove the board but have the option of putting it back in the plastic case at a later date, once
my project is finished and I wish to reuse the DFG/USB2pro.

Thanks!

Stefan Geissler
January 11, 2013, 15:00:25
Hi

First of all, the housing is not intended to be opened.

The housing is not glued. You can try to open it carefully. Usually you can mount the housing again, after it was opened. There is no special trick for opening.