fujung1009
December 16, 2011, 07:42:15
Hello,
I know this forum been a long time without new post, anyway, I'll have a try.
when I open the "video over network" sample project shows as fig1, I make change as fig2 and run as fig3, finally save the change, reopen the file it shows as fig1, why?
best regards
Bobby Chen
I know this forum been a long time without new post, anyway, I'll have a try.
when I open the "video over network" sample project shows as fig1, I make change as fig2 and run as fig3, finally save the change, reopen the file it shows as fig1, why?
best regards
Bobby Chen