View Full Version : Labview 2010 compiled software won't work without IC Control installed on client PC

dan acres
January 12, 2011, 14:49:51
I'm using a DMK 41BU02 with labview 2010 + IC Labview extension.
The activeX interface for the camera works fine until I deploy it to a PC that does not have the IC Control software installed.

All I see is a 'Control could not be loaded' message where the activeX box should be.

I've installed VB6 redistributable to the client PC so I know the activeX workings should be present on the PC.

If I install IC Control onto the PC the program starts working correctly!

Has anyone compiled software with Labview 2010 successfully?
Is there a trick when creating the application/installer spec?

Thanks in advance

Dan Acres

Stefan Geissler
January 12, 2011, 16:54:28
This is correct. I suppose, the LabVIEW setup creating system does not automatically add the used DLL in the "user.lib" directory of your LabVIEW installation path. What does the LabVIEW support say about this, especially in relation to ActiveX controls, that use the Microsoft licensing mechanism?