PDA

View Full Version : White Balance and Auto Exposure



Unregistered
April 9, 2005, 17:00:54
Hi,
when I set my SONY DFWSX910 camera with ICCapture, setting Auto White Balance, I obtain a perfect image.
When I open the same camera with my VB software based on ICControl2.0 the image starts seeming well but becaming progressive white moving to a total while image.
Maybe I set wrong some property of the control?

Thanks

Stefan Geissler
April 11, 2005, 09:16:15
Hello,

This sounds for a problem with autoexposure.
I assume, auto exposure is enabled. Did you change something at the auto exposure reference value (if available)? This value sets the reference brightness for the calculation of exposure. If it is set to a high value, you will get a very bright image.

If this was not the cause for your problem, you may send your project as zipped file to support@imagingcontrol.com, so i can have a look on it.