PDA

View Full Version : Standart License and foreign frame grabber cards



Unregistered
November 8, 2004, 17:20:12
Hello all!
We are trying to replace our frame grabber boards by a FW camera and I was trying to build an application with IC Standard Version 2.0. In addition to the FW Camera two frame grabber boards ( Eltec PC_EYE2 and p3i CVBS) are installed in my computer.
Using the trial version of IC Capture everything works fine. When I try to run my application or one of the demo applications built with our Key, I do not have the chance to select the grabber.

Is there anything I can do?

Best regards

Jens

JensRichter
November 9, 2004, 07:49:32
Hello again! (now registered ;-) )

The solution was simple. I just did not install the drivers four our camera. IC Capture worked fine with the generic IEEE1394 device since it must be compiled with the professional license.
After the driver installation everything works fine now.

Best regards
Jens